2021.12.27
ECO+ Panels Tested by SGS
.jpg)
ECO+ Panels are made of PP Film laminated onto select plywood and block board.
*ECO+ Panels: PP (Polypropylene) raw materials are free of formaldehyde, plasticizers, TVOCs and other toxic substances. It has a heat-resistance range of -20 ℃ to 120 ℃, which is the raw material for microwave special plastic box.
*Block board: Block Board is made of solid wood strips stacked and glued together, providing firm and solid structure, good load-bearing capacity, and is fairly more resistant to moisture, this is one of the best core materials for making durable cabinets. Adhesive is made from a variety of chemical materials, common ingredients include formaldehyde, melamine, and other toxins, however the content level of these meet the national safety testing standards for building materials and daily necessities. It is recommended to purchase F1 low-formaldehyde substrates. F1 and F3 block board available at KD.
Emission of Formaldehyde
Testing Method | Glass Desiccator Analysis Method | Emission Test Chamber Method | ||
Formaldehyde Emmission | TAIWAN CNS | Japan JIS | CHINA GB | EUROPE ISO |
≦ 0.025mg/m3 | ENF ≦0.025mg/m3 | |||
≦ 0.050mg/m3 | E0 ≦0.050mg/m3 | |||
≦ 0.124mg/m3 | F1 ≦ 0.3mg/L | F★★★★ ≦ 0.4mg/L | E1 ≦0.124mg/m3 | E1 ≦0.124mg/m3 |
F2 ≦ 0.5mg/L | F★★★ ≦ 0.7mg/L | E2 >0.124mg/m3 | ||
F3 ≦ 1.5mg/L | F★★ ≦ 2.1mg/L |
ECO+ Panels SGS Testing Report
*Emission of formaldehyde is lower than minimum detecting, therefore, it is considered as “undetected.”
*Plasticizers undetected.
![]() | ![]() |
Formaldehyde Emmission | Plasticizer |
TAIWAN CNS 7308: Glass Desiccator Chemical Analysis:
Put distilled water at the bottom of the desiccator to absorb the formaldehyde released by the sample, and measure the formaldehyde content of the distilled water after 24 hours.